Show simple item record

dc.contributor.authorL. C. Bank
dc.contributor.authorT. D. Gerhardt
dc.contributor.authorE. Cofie
dc.date.accessioned2017-05-08T23:38:38Z
dc.date.available2017-05-08T23:38:38Z
dc.date.copyrightJanuary, 1992
dc.date.issued1992
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26946#84_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110362
dc.description.abstractA new static test method to determine the flexural modulus of spirally wound paper tubes is described. The experimental method is based on the standard three-point-bend procedure. The method requires testing the tube at multiple (two or more) span lengths. The testing can be performed on either a rigid frame fixture under constant static load or in a universal testing machine under monotonically increasing quasi-static load. The test data are analyzed with a modified form of a classical Euler-Bernoulli beam theory. The modified theory accounts for nonbending deflection components that are obtained with the three-point-bend test. The effect of time-dependent creep deflection on the modulus prediction is also discussed. Extensive testing of a variety of paper tubes was conducted to verify the proposed test method. The accuracy of the method was determined by comparison with dynamic bending modulus predictions obtained from modal tests on the tubes. The dynamic modulus predictions were based on Euler-Bernoulli beam theory. Results of tests performed on a specially designed static frame fixture and tests performed on a universal testing machine are compared. It is found that the bending modulus predictions using the new analysis method are considerably closer to the dynamic bending modulus than those predictions obtained by classical beam theory.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA New Test Method for the Determination of the Flexural Modulus of Spirally Wound Paper Tubes
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904146
dc.journal.fristpage84
dc.journal.lastpage89
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsMachinery
dc.keywordsStress
dc.keywordsJigs and fixtures
dc.keywordsStructural frames
dc.keywordsTesting AND Deflection
dc.treeJournal of Engineering Materials and Technology:;1992:;volume( 114 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record