Show simple item record

dc.contributor.authorJ. M. Fragomeni
dc.contributor.authorT. H. Sanders
dc.contributor.authorA. G. Gaitatzes
dc.contributor.authorB. M. Hillberry
dc.date.accessioned2017-05-08T23:38:36Z
dc.date.available2017-05-08T23:38:36Z
dc.date.copyrightJanuary, 1992
dc.date.issued1992
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26946#34_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110352
dc.description.abstractThis investigation incorporates the development and control of microstructure and properties into a computer aided design/computer aided manufacturing (CAD/CAM) environment for materials design. An integrated computer model has been developed which predicts the microstructure and properties based on the material processing and the material composition. The material processing includes the extrusion parameters and the aging conditions employed during heat treatment. The material being utilized as a demonstration medium is a special precipitation hardenable aluminum-lithium-zirconium (Al-Li-Zr) alloy which has been direct-chill (D.C.) cast and direct extruded. A model has been developed based on a series of quantitative transmission electron microscopy (TEM) investigations to predict microstructure from the composition and material processing. This model, referred to as the microstructural model, provides the basis for the overall CAD/CAM model for materials design. Also included is an analysis of the microstructural mechanisms that contribute to the strengthening of precipitation hardened alloys that contain shearable precipitates. A number of existing models regarding particle shearing and looping mechanisms in precipitation hardened systems were evaluated regarding their suitability in describing the Al-Li aging and strengthening behavior. These analytical models are incorporated with the microstructural model to make theoretical predictions for the critical resolved shear strength.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleIntegration of Microstructural Development and Properties Design Into the CAD/CAM Environment
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904137
dc.journal.fristpage34
dc.journal.lastpage40
dc.identifier.eissn1528-8889
dc.keywordsDesign
dc.keywordsComputer-aided design
dc.keywordsPrecipitation
dc.keywordsMaterials processing
dc.keywordsAlloys
dc.keywordsZirconium
dc.keywordsMechanisms
dc.keywordsComputer-aided manufacturing
dc.keywordsShear strength
dc.keywordsShearing
dc.keywordsTransmission electron microscopy
dc.keywordsParticulate matter
dc.keywordsExtruding
dc.keywordsHeat treating (Metalworking)
dc.keywordsComputers
dc.keywordsLithium AND Aluminum
dc.treeJournal of Engineering Materials and Technology:;1992:;volume( 114 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record