Show simple item record

dc.contributor.authorZ. C. Lin
dc.contributor.authorS. Y. Lin
dc.date.accessioned2017-05-08T23:38:36Z
dc.date.available2017-05-08T23:38:36Z
dc.date.copyrightApril, 1992
dc.date.issued1992
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26950#218_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110344
dc.description.abstractIn this paper, a coupled model of the thermo-elastic-plastic material under large deformation for orthogonal cutting is constructed. A chip separation criterion based on the critical value of the strain energy density is introduced into the analytical model. A scheme of twin node processing and a concept of loading/unloading are also presented for chip formation. The flow stress is taken as a function of strain, strain rate and temperature in order to reflect realistic behavior in metal cutting. The cutting tool is incrementally advanced forward from an incipient stage of tool-workpiece engagement to a steady state of chip formation. The finite difference method is adopted to determine the temperature distribution within the chip and tool, and a finite element method, which is based on the thermo-elastic-plastic large deformation model, is used to simulate the entire metal cutting process. Finally, the chip geometry, residual stresses in the machined surface, temperature distributions within the chip and tool, and tool forces are obtained by simulation. The calculated cutting forces agree quite well with the experimental results. It has also been verified that the chip separation criterion value based on the strain energy density is a material constant and is independent of uncut chip thickness.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Coupled Finite Element Model of Thermo-Elastic-Plastic Large Deformation for Orthogonal Cutting
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904165
dc.journal.fristpage218
dc.journal.lastpage226
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsCutting
dc.keywordsFinite element model
dc.keywordsTemperature distribution
dc.keywordsDensity
dc.keywordsForce
dc.keywordsSeparation (Technology)
dc.keywordsMetal cutting
dc.keywordsResidual stresses
dc.keywordsSimulation
dc.keywordsStress
dc.keywordsCutting tools
dc.keywordsFinite element methods
dc.keywordsFlow (Dynamics)
dc.keywordsTemperature
dc.keywordsThickness
dc.keywordsGeometry
dc.keywordsSteady state AND Finite difference methods
dc.treeJournal of Engineering Materials and Technology:;1992:;volume( 114 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record