Show simple item record

dc.contributor.authorK. J. Hsia
dc.contributor.authorA. S. Argon
dc.contributor.authorD. M. Parks
dc.date.accessioned2017-05-08T23:38:33Z
dc.date.available2017-05-08T23:38:33Z
dc.date.copyrightJuly, 1992
dc.date.issued1992
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26951#255_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110315
dc.description.abstractThe competing effects of failure by net section stress rupture and failure due to crack growth in creeping structural alloys have been investigated to determine the dominant failure process under various constant load service conditions. Two sets of experimental information were utilized: times to failure by quasi-homogeneous damage accumulation represented by Larson-Miller master curves, and creep crack growth rate information correlated either with C* for creep-ductile materials or with K for creep-brittle materials. A criterion, phrased in terms of the applied stress, temperature and initial crack length, has been established to justify the rate-determining fracture process. A number of materials, ranging from ductile materials such as Type 304 stainless steel, IN800H and low alloy steels obeying C*-controlled crack growth, to brittle materials such as Ni-based superalloys obeying K-controlled crack growth, have been studied. Both the configurations of infinite bodies and finitesize specimens were considered. The results show that for those materials where crack growth is C*-controlled, eventual failure is governed by quasi-homogeneous creep damage accumulation; whereas, for the materials with K-controlled crack growth, creep crack growth is likely to govern the final failure of engineering structures.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDominant Creep Failure Process in Tensile Components
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904170
dc.journal.fristpage255
dc.journal.lastpage264
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsFailure
dc.keywordsStress
dc.keywordsAlloys
dc.keywordsBrittleness
dc.keywordsSteel
dc.keywordsSuperalloys
dc.keywordsTemperature
dc.keywordsStructures
dc.keywordsFracture (Process)
dc.keywordsRupture AND Stainless steel
dc.treeJournal of Engineering Materials and Technology:;1992:;volume( 114 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record