Show simple item record

dc.contributor.authorV. S. V. Rajan
dc.contributor.authorR. Tipman
dc.date.accessioned2017-05-08T23:38:10Z
dc.date.available2017-05-08T23:38:10Z
dc.date.copyrightDecember, 1992
dc.date.issued1992
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26447#261_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/110105
dc.description.abstractBituminous froths produced from the water extraction of oil sands contain significant quantities of sand and water which must be removed prior to upgrading the bitumen to synthetic crude oil. This paper presents a summary of the study of a simple twostep process for removing most of the solid and water contaminants from the bituminous froth. Low-quality froths containing 10–30 percent bitumen at temperatures of 40–70°C were improved in quality to 50–60 percent bitumen by heating the raw froth to ~ 90°C and settling the product in a gravity settler. The gravity settling vessel incorporated unique features for the introduction of the hot froth into the vessel. Two types of froth heaters were tested: a column heater containing a structured grid packing which used live steam injection, and a shell and tube heat exchanger. Heat transfer data were obtained for both types of heaters in the range of froth flow conditions available in the pilot plant. There was no apparent difference between the two heating modes in terms of the froth quality improvement, but the direct contact heater had the benefit of deaerating the froth. Evaluation of the separation efficiency showed that the gravity separation vessel design performed very well, and hence was incorporated into a commercial froth cleaning plant design. The bitumen separation efficiency was the best for froths containing about 20 percent bitumen. There was no apparent improvement in the froth quality for froths containing over 65 percent bitumen.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Method for Improving the Quality of Bituminous Froth From Water Extraction of Oil Sands
dc.typeJournal Paper
dc.journal.volume114
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905951
dc.journal.fristpage261
dc.journal.lastpage266
dc.identifier.eissn1528-8994
dc.keywordsSands
dc.keywordsWater abstraction
dc.keywordsPitch (Bituminous material)
dc.keywordsGravity (Force)
dc.keywordsVessels
dc.keywordsSeparation (Technology)
dc.keywordsWater
dc.keywordsHeating
dc.keywordsPlant design
dc.keywordsDesign
dc.keywordsHeat exchangers
dc.keywordsIndustrial plants
dc.keywordsShells
dc.keywordsSteam
dc.keywordsFlow (Dynamics)
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsSynthetic petroleum AND Packing (Shipments)
dc.treeJournal of Energy Resources Technology:;1992:;volume( 114 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record