Show simple item record

dc.contributor.authorH. G. deLorenzi
dc.contributor.authorH. F. Nied
dc.contributor.authorC. A. Taylor
dc.date.accessioned2017-05-08T23:36:27Z
dc.date.available2017-05-08T23:36:27Z
dc.date.copyrightFebruary, 1991
dc.date.issued1991
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28324#102_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/109101
dc.description.abstractThis paper describes a combined numerical and experimental approach to the development of a software package for simulating the thermoforming process. In this process thin polymer sheets are forced under pressure into a mold cavity. During the forming process the polymer is subjected to large deformations, which result in severe nonuniform thinning. The development of the simulation software was facilitated by a close interaction between numerical modeling and experiment. On the one hand, experimental results guided the development of the software, and on the other hand, numerical developments have been used to suggest new experiments to be performed and critical quantities to be measured. The numerical software is based on the finite element method and the hot polymer is modeled as a nonlinear elastic membrane. Because of the very large deformations occurring in this process, a rigorous large deformation theory has been employed. The numerical formulation also contains contact capabilities for contact between the polymer and the mold and for contact between different parts of the polymer itself. Since very little was known about the physical processes before the program was started, especially about the material behavior and temperatures involved, carefully planned experiments were carried out to guide the selection of the material models used in the software. Since there also was a widespread misconception about the nature of some of the process parameters involved, numerical calculations were used to suggest measurements to be performed on some of these critical parameters. Excellent correlation between calculations and experiment have been obtained and are presented in the paper.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Numerical/Experimental Approach to Software Development for Thermoforming Simulations (Survey Paper)
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2928719
dc.journal.fristpage102
dc.journal.lastpage114
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsDeformation
dc.keywordsTemperature
dc.keywordsMeasurement
dc.keywordsComputer simulation
dc.keywordsSimulation
dc.keywordsFinite element methods
dc.keywordsEngineering simulation
dc.keywordsPolymers
dc.keywordsCavities
dc.keywordsComputer software
dc.keywordsMembranes AND Software development
dc.treeJournal of Pressure Vessel Technology:;1991:;volume( 113 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record