Show simple item record

dc.contributor.authorE. C. Goodling
dc.date.accessioned2017-05-08T23:36:25Z
dc.date.available2017-05-08T23:36:25Z
dc.date.copyrightMay, 1991
dc.date.issued1991
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28326#332_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/109083
dc.description.abstractDynamic transients such as steam hammer or water hammer in power plant or process piping can generate high destructive reactions if rigid restraints or snubbers are used in an attempt to exert total control of pipe response. However, where some movement can be tolerated, adequate control can be maintained with much lower resulting loads in the restraining structures and components. The disk spring restraint has been demonstrated to be a practical device for controlling piping movements caused by typical dynamic upset conditions in steam and boiler feedwater piping and in drain lines carrying mixed phase (water and vapor) flow. This paper discusses the simplified mathematics used in estimating loads to design disk spring restraints for such applications.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleControl of Pipeline Dynamics With Disk Spring Restraints (Design Paper)
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2928763
dc.journal.fristpage332
dc.journal.lastpage336
dc.identifier.eissn1528-8978
dc.keywordsDynamics (Mechanics)
dc.keywordsDesign
dc.keywordsPipelines
dc.keywordsDisks
dc.keywordsSprings
dc.keywordsPipes
dc.keywordsStress
dc.keywordsSteam hammers
dc.keywordsFeedwater
dc.keywordsWater hammer
dc.keywordsFlow (Dynamics)
dc.keywordsVapors
dc.keywordsMotion
dc.keywordsPower stations
dc.keywordsSteam
dc.keywordsWater AND Process piping
dc.treeJournal of Pressure Vessel Technology:;1991:;volume( 113 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record