Show simple item record

dc.contributor.authorM.-D. Xue
dc.contributor.authorY. Deng
dc.contributor.authorK.-C. Hwang
dc.date.accessioned2017-05-08T23:36:25Z
dc.date.available2017-05-08T23:36:25Z
dc.date.copyrightMay, 1991
dc.date.issued1991
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28326#297_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/109077
dc.description.abstractAn analytical solution for cylindrical shells with large openings has been developed by the asymptotic method. In comparison with previous analytical solutions obtained by Eringen, Van Dyke and Lekkerkerker, the following three areas have been improved by the present method: 1) The modified Morley’s equation, which is applicable to ro/RT ≫ 1, is used instead of Donnell’s shallow shell equation. 2) The accurate expression of boundary curve of hole is expanded in terms of powers of ρo = ro /R , while the previous approximate geometric description corresponds to the first term of the expansion. 3) The accurate boundary conditions for generalized forces are expanded in terms of powers of ρo and truncated after the terms of ρo 3 ; the previous approximate boundary conditions correspond to the terms of order up to ρo , in the asymptotic expansions. The present solutions are in good agreement with Van Dyke’s solutions for small openings. The analytical results show that the error caused by the previous approximate boundary conditions is significant and has the order O(ρo ); the error caused by the previous approximate geometric description of hole boundary has the order O(ρo 2 ); and finally, the error caused by using Donnell’s shallow shell equation is very small for ρo ≤ 0.7. For openings with ρo > 0.25, say, noticeable differences exist between the present and the previous results. The stress analysis of cylindrical shells connected with nozzles has been developed by using the present solution. For increasing the accuracy of stress analysis in the nozzle, the exact description of the edge of nozzle is given and the near-edge boundary layer stress state in the nozzle is considered. The results obtained are in good agreement with those by Eringen for small openings and with those by F.E.M. and experiments for large openings.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleSome Results on the Analytical Solution of Cylindrical Shells With Large Openings
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2928758
dc.journal.fristpage297
dc.journal.lastpage307
dc.identifier.eissn1528-8978
dc.keywordsPipes
dc.keywordsNozzles
dc.keywordsBoundary-value problems
dc.keywordsEquations
dc.keywordsErrors
dc.keywordsShells
dc.keywordsStress analysis (Engineering)
dc.keywordsBoundary layers
dc.keywordsForce
dc.keywordsStress AND Levees
dc.treeJournal of Pressure Vessel Technology:;1991:;volume( 113 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record