Show simple item record

dc.contributor.authorR. J. Scavuzzo
dc.contributor.authorP. C. Lam
dc.contributor.authorJ. S. Gau
dc.date.accessioned2017-05-08T23:36:24Z
dc.date.available2017-05-08T23:36:24Z
dc.date.copyrightMay, 1991
dc.date.issued1991
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28326#210_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/109066
dc.description.abstractIn these studies, both dynamic and static tests were conducted on pressurized pipe. Dynamic tests were run on 1 in. Schedule 40 and Schedule 10 seamless 304 stainless steel pipe. Welded 1 in. Schedule 40 304 stainless steel pipe and seamless carbon steel (ASTM A106) pipe were tested statically. Internal pressures varied from 1000 psi to 3000 psi. In these tests, axial bending stresses from either inertial loads or static loads were superposed on to the initial pressure stresses. Strain gages were used to measure the cyclic strains on the outer walls of the pipe. Measurements indicated that ratcheting occurred primarily in the hoop direction and varied from a maximum at the top and bottom of the pipe that had the highest bending stresses to zero at the neutral axis. Though ratcheting occurred primarily in the hoop direction, some ratcheting in the axial direction was observed in 304 stainless steel pipe in both static and dynamic tests. Axial ratcheting was insignificant in the carbon steel pipe. Data obtained from these tests are presented. Measured ratcheting strains are compared to approximations of Beaney, Edmunds and Beer and to finite element computations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Studies of Ratcheting of Pressurized Pipe
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2928748
dc.journal.fristpage210
dc.journal.lastpage218
dc.identifier.eissn1528-8978
dc.keywordsPipes
dc.keywordsStress
dc.keywordsStainless steel
dc.keywordsCarbon steel
dc.keywordsDynamic testing (Engineering)
dc.keywordsBending (Stress)
dc.keywordsFinite element analysis
dc.keywordsApproximation
dc.keywordsComputation
dc.keywordsExterior walls
dc.keywordsPressure
dc.keywordsMeasurement
dc.keywordsStrain gages AND ASTM International
dc.treeJournal of Pressure Vessel Technology:;1991:;volume( 113 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record