Show simple item record

dc.contributor.authorP. B. Crosley
dc.contributor.authorE. J. Ripling
dc.date.accessioned2017-05-08T23:36:20Z
dc.date.available2017-05-08T23:36:20Z
dc.date.copyrightAugust, 1991
dc.date.issued1991
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28329#380_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/109035
dc.description.abstractSafety of structures can be assured, even if cracks initiate in localized regions of abnormally low toughness, and/or abnormally high stress (LT/HS), if the materials from which they are fabricated have a high enough crack arrest fracture toughness. When this requirement is met, fast-running cracks that initiate in LT/HS regions arrest when their tip encounters material having normal toughness and stresses. The work described in this paper was carried out to determine the crack arrest capability of LNG storage tanks by determining the longest LT/HS region in which a crack could initiate and still arrest when it leaves this region. The determination consisted of relating a fracture analysis with the measured full-thickness crack arrest fracture toughness of three 9-percent Ni plates which were reported in reference [1]. The calculations used a residual stress pattern, produced by welding, superimposed on a typical membrane stress. The residual stress was selected as an example of a localized high stress region. It was found that tanks built from the poorest of the three tested plates could arrest cracks about 3/4 m long, while tanks built from the two tougher plates could arrest cracks almost 2 m long.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Crack Arrest Capability of 9-Percent Ni Steels (ASTM 553, Type 1) LNG Storage Tanks
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2928770
dc.journal.fristpage380
dc.journal.lastpage384
dc.identifier.eissn1528-8978
dc.keywordsSteel
dc.keywordsFracture (Materials)
dc.keywordsLiquefied natural gas
dc.keywordsASTM International
dc.keywordsStorage tanks
dc.keywordsStress
dc.keywordsPlates (structures)
dc.keywordsFracture toughness
dc.keywordsToughness
dc.keywordsMembranes
dc.keywordsThickness
dc.keywordsFracture (Process)
dc.keywordsWelding AND Safety
dc.treeJournal of Pressure Vessel Technology:;1991:;volume( 113 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record