Show simple item record

dc.contributor.authorR. Viswanathan
dc.contributor.authorS. Gehl
dc.date.accessioned2017-05-08T23:35:41Z
dc.date.available2017-05-08T23:35:41Z
dc.date.copyrightApril, 1991
dc.date.issued1991
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26942#263_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/108631
dc.description.abstractAssessment of the remaining life of steam turbine rotors in the presence of bore defects requires a knowledge of the fracture toughness (KIC ) of the rotors. Current procedures for estimating the KIC involve two steps; as a first step, the fracture appearance transition temperature (FATT) at the critical location is determined; the FATT value is then used to estimate the KIC , based on published correlations between the excess temperature (T-FATT) and KIC . Some problems arise in implementing both of these steps. To determine the FATT of the material, large pieces of material have to be removed, machined into charpy specimens and tested; this procedure is often time consuming and expensive and sometimes not feasible. The excess temperatures versus the KIC correlation that is used to derive the KIC values from the FATT data is based on a variety of low alloy steels and is therefore characterized by a large scatter band, thus leading to considerable uncertainty in the estimated KIC . In this work, FATT and KIC data reported for a number of retired CrMoV rotors were gathered and analyzed and correlations specific to CrMoV rotors were developed. Based on these correlations, a method for estimating KIC with greater accuracy, based on a knowledge of the steel chemistry alone, is proposed. The method offers the advantage that very small samples removed from noncritical locations in the rotor would be sufficient to get the desired data.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Method for Estimation of the Fracture Toughness of CrMoV Rotor Steels Based on Composition
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903401
dc.journal.fristpage263
dc.journal.lastpage270
dc.identifier.eissn1528-8889
dc.keywordsSteel
dc.keywordsRotors
dc.keywordsFracture toughness
dc.keywordsTemperature
dc.keywordsAlloys
dc.keywordsChemistry
dc.keywordsProduct quality
dc.keywordsPhase transition temperature
dc.keywordsElectromagnetic scattering
dc.keywordsFracture (Process)
dc.keywordsSteam turbines AND Uncertainty
dc.treeJournal of Engineering Materials and Technology:;1991:;volume( 113 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record