Show simple item record

dc.contributor.authorE. Emel
dc.contributor.authorE. Kannatey-Asibu
dc.date.accessioned2017-05-08T23:35:38Z
dc.date.available2017-05-08T23:35:38Z
dc.date.copyrightOctober, 1991
dc.date.issued1991
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26945#456_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/108599
dc.description.abstractEarlier work has shown tool failure monitoring using frequency-based pattern recognition analysis of acoustic emission signals to be feasible while machining under fixed cutting conditions. However, cutting conditions change quite frequently in industrial production, and since AE signals are affected by varying conditions, a model is developed based on Taylor’s expansion using experimental data obtained for various process variables and their output AE spectra, and is used to filter the influence of varying conditions on signal classification. The experimental study involved a fractional factorial experimental design which delineated effects of variables on AE generation during machining. Normalized AE spectra within the 100 to 1000 kHz range were used as system output along with the AE power. While the normalized spectra were found unaffected by changes in the depth of cut, the total AE power was also little affected by the mixed flank and crater wear, and feed rate changes. Using the model and filter designed, performance of the tool wear, chip noise and tool breakage classifier improved to 83, 99, and 97 percent classification, respectively.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAcoustic Emission Monitoring of the Cutting Process—Negating the Influence of Varying Conditions
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2904126
dc.journal.fristpage456
dc.journal.lastpage464
dc.identifier.eissn1528-8889
dc.keywordsAcoustic emissions
dc.keywordsCutting
dc.keywordsSpectra (Spectroscopy)
dc.keywordsSignals
dc.keywordsWear
dc.keywordsMachining
dc.keywordsFilters
dc.keywordsPattern recognition
dc.keywordsNoise (Sound)
dc.keywordsExperimental design AND Failure
dc.treeJournal of Engineering Materials and Technology:;1991:;volume( 113 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record