Show simple item record

dc.contributor.authorD. W. Dareing
dc.contributor.authorC. A. Ahlers
dc.date.accessioned2017-05-08T23:35:23Z
dc.date.available2017-05-08T23:35:23Z
dc.date.copyrightJune, 1991
dc.date.issued1991
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26438#133_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/108466
dc.description.abstractThis paper is concerned with drag forces developed on tubulars in high-curvature well bores typically found in drainhole and horizontal drilling. The dog-leg severity of these types of boreholes are considerably higher than those typically found in conventional directional drilling. The objective of the study was to determine the significance of bending stiffness on drag forces in the pull-out mode. The method of analysis treats the tubular as a multi-spanned curved beam under tension and solves for radial displacements, slope, shear and bending moment over each span. Calculations show that bending stiffness is a minor factor provided there are no locally severe dog legs superimposed in the high-curvature well bore.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTubular Bending and Pull-Out Forces in High-Curvature Well Bores
dc.typeJournal Paper
dc.journal.volume113
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905787
dc.journal.fristpage133
dc.journal.lastpage139
dc.identifier.eissn1528-8994
dc.keywordsForce
dc.treeJournal of Energy Resources Technology:;1991:;volume( 113 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record