• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Investigation of Residual Stresses in Drawn Wire by the Finite Element Method

    Thumbnail
    View/Open
    JEMTA8-26934#231_1.pdf (498.6Kb)
    Date
    1990
    Author
    K. Sawamiphakdi
    P. K. Kropp
    G. D. Lahoti
    Metadata
    Show full item record
    Abstract
    Based on a finite element modeling of the wire drawing process, a parametric study was conducted to investigate the effects of die geometry and area reduction factor on the magnitude and distribution of residual stresses through the wire cross section at the die exit. Two major variables of die geometry were considered in the study: the die radius and the die inlet angle. Three different die inlet angles of 12.5, 16.0 and 22.0 degrees were used in the analyses while the die radius was fixed at 25.4 mm. The die inlet angle was then set at 16.0 degrees and the die radius was varied from 12.7 mm through 38.1 mm in 12.7 mm increments. For each of the above cases, the area reduction factor was considered for 16.0 and 20.0 percents. In addition, the effect of initial stresses in wire was also investigated. The calculated results were compared to the analytical results published in the literature and an excellent agreement was obtained. The parametric study indicated that the die inlet angle has significant effect on the residual stresses at the surface of drawn wire. Specifically, smaller die inlet angle causes less tensile stresses at the surface and more compressive stresses at the center. The larger die radius reduces the level of residual stresses, but this reduction is only marginal. No significant change in either magnitude or distribution on patterns of residual stresses due to the initial stresses were found.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/107021
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV