Show simple item record

dc.contributor.authorS. S. Chiu
dc.contributor.authorJ. Eftis
dc.contributor.authorD. L. Jones
dc.date.accessioned2017-05-08T23:32:48Z
dc.date.available2017-05-08T23:32:48Z
dc.date.copyrightApril, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26934#188_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/107014
dc.description.abstractThe titanium alloy Ti-6Al-4V is known to exhibit creep behavior at temperatures as low as room temperature. Consequently, for cyclic loading with hold times it is possible that the rate dependent behavior of Ti-6Al-4V can have negative bearing upon the low cycle fatigue life. If this effect is shown to be present at room temperatures, then it will certainly be magnified and, therefore, very important at elevated temperatures. In order to account for the effects of strain rate dependent deformation in fatigue life prediction methodology, it was considered necessary to incorporate a viscoplastic constitutive equation into the fatigue life calculational algorithm. After critical evaluation of a score of recently proposed viscoplastic constitutive theories, the Chaboche theory, which employs a yield condition, was considered to offer the most promise for description of a wide range of inelastic material behavior characteristics. The six viscoplastic material parameters that are required for nonelevated temperature applications were determined from data of uniaxial tests, conducted elsewhere and made avialable to this study. The fatigue life testing of smooth round bar specimens included load cycles with load hold times. Fatigue life predictions were performed using the equivalent fully reversed symmetric cycle, and the Smith-Watson-Topper parameter, for load cycles having varying stress amplitudes and varying hold times. The predicted fatigue life results indicate that: (i) For a given stress level above the initial yield stress, shorter load hold time periods result in longer fatigue lives. (ii) The higher the stress level (above the initial yield stress) the more pronounced becomes the effect of the load hold time on the fatigue life prediction. (iii) The rate of loading also has an effect on fatigue life. Analysis indicates that the slower the rate of loading, the higher the rate dependent (primary creep) deformation, and consequently, the lower the resulting fatigue life.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePrediction of Fatigue Life With and Without Hold Times Using the Chaboche Viscoplastic Constitutive Theory
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903306
dc.journal.fristpage188
dc.journal.lastpage197
dc.identifier.eissn1528-8889
dc.keywordsFatigue life
dc.keywordsStress
dc.keywordsTemperature
dc.keywordsCycles
dc.keywordsYield stress
dc.keywordsDeformation
dc.keywordsCreep
dc.keywordsFatigue
dc.keywordsTitanium alloys
dc.keywordsAlgorithms
dc.keywordsBearings
dc.keywordsTesting
dc.keywordsEquations AND Low cycle fatigue
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record