Show simple item record

dc.contributor.authorY. Oshida
dc.contributor.authorA. Deguchi
dc.date.accessioned2017-05-08T23:32:46Z
dc.date.available2017-05-08T23:32:46Z
dc.date.copyrightJuly, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26937#362_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106999
dc.description.abstractLow temperature stationary creep strain in a metastable austenitic stainless steel was studied at −162°C under various combinations of prestrain and stress ratio. It was found that the amount of transformed martensite during low temperature stressing increased with the number of thermal cycles as well as the degree of prestrain and stress ratio. When the applied stress exceeded 70 percent of the material yield strength at −162°C, the martensite volume increased significantly. At the same time, the stationary low temperature creep rate exceeded 1.8x10−10 (s−1 ), which would cause approximately 0.44 percent strain after continuous operation for a year.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLow Temperature Isothermal Strain in a Metastable Austenitic Stainless Steel Sheet
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903339
dc.journal.fristpage362
dc.journal.lastpage365
dc.identifier.eissn1528-8889
dc.keywordsLow temperature
dc.keywordsStainless steel
dc.keywordsStress
dc.keywordsCreep
dc.keywordsCycles AND Yield strength
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record