Show simple item record

dc.contributor.authorM. Tanaka
dc.contributor.authorH. Iizuka
dc.contributor.authorF. Ashihara
dc.date.accessioned2017-05-08T23:32:46Z
dc.date.available2017-05-08T23:32:46Z
dc.date.copyrightJuly, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26937#353_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106997
dc.description.abstractEffects of grain-boundary sliding and strenthening by serrated grain boundaries on creep-crack growth are investigated using an austenitic 21Cr-4Ni-9Mn steel at 973 K in air. In surface notched specimens, crack growth rate is lower in specimens with serrated grain boundaries than in those with normal straight grain boundaries at the same stress intensity factor (K1 ), but the difference in crack growth rate between these specimens decreases with crack growth. In smooth bar specimens, growth rate of the largest surface crack is correlated with the average amount of grain-boundary sliding, although a unique relationship is not found between them. Grain-boundary sliding controls the crack growth when the crack size is small, but total creep deformation becomes important and crack linkage occurs with increasing crack length, thus reducing the strengthening effects of serrated grain boundaries.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCreep Crack Growth in an Austenitic Cr-Ni-Mn Steel
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903337
dc.journal.fristpage353
dc.journal.lastpage357
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsSteel
dc.keywordsFracture (Materials)
dc.keywordsGrain boundaries
dc.keywordsStress
dc.keywordsLinkages AND Surface cracks
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record