Show simple item record

dc.contributor.authorH. Inoue
dc.contributor.authorI. Kawaguchi
dc.date.accessioned2017-05-08T23:32:45Z
dc.date.available2017-05-08T23:32:45Z
dc.date.copyrightJuly, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26937#341_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106995
dc.description.abstractIn order to clarify the grinding mechanism of polymer matrix composites, special test specimens were provided. The test specimen is such one that glass yarns are unidirectionally embedded at even interval on the middle plane of thick of a polymer matrix plate. The end face perpendicular to the plane on which glass yarns are lined up is ground in the direction at various angle from the direction of glass yarn. The aspects of the cut end of the glass yarn near the ground surface are observed microscopically, and relations between the angle of the direction of yarn and the topography of the ground surface are investigated. Following results are obtained. (1) The microscopically observed aspects of failure of the end of yarns near the ground surfaces are classified into two modes by the direction of yarn measured counterclockwise from the direction of grinding. In the range from 0 rad. to π/3 rad. of the angle, the failure of the end of yarn is comparatively deep, and spreads over the whole section of the yarn. In the range from π/2 rad. to π rad. of the angle, the failure of the end of the yarn is comparatively shallow, and random in the depth and the spread. (2) The topography is also classified into two types by the above angle. In the range from 0 rad. to π/3 rad. of the angle, the end of yarn forms a hollow pit, and in the range from π/2 rad. to π rad., the end of yarn forms a swollen proturberance. (3) The above facts are well understood by considering the digging up action of the grinding grain in the range from 0 rad. to π/3 rad., and the push down action of the grain in the range from π/2 rad. to π rad. in the grinding process.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStudy on the Grinding Mechanism of Glass Fiber Reinforced Plastics
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903335
dc.journal.fristpage341
dc.journal.lastpage345
dc.identifier.eissn1528-8889
dc.keywordsGlass reinforced plastics
dc.keywordsGrinding
dc.keywordsMechanisms
dc.keywordsYarns
dc.keywordsGlass
dc.keywordsFailure
dc.keywordsPolymer composites AND Polymers
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail
This item appears in the following Collection(s)

Show simple item record