Show simple item record

dc.contributor.authorD. W. Schmueser
dc.date.accessioned2017-05-08T23:32:44Z
dc.date.available2017-05-08T23:32:44Z
dc.date.copyrightJuly, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26937#321_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106992
dc.description.abstractStructural applications of adhesive bonding have been increasing in recent years due to improvements in the types of adhesives available and in improved knowledge of bondline procedures. Consequently, there exists a demand for precise numerical modeling of adhesive joint behavior, particularly along bondline interfaces where low surface energy adhesives contact high surface energy metallic oxides. Recent experimental studies have shown that adhesive bond strength for steel substrates which had been cathodically electroprimed (ELPO-primed) before bonding were significantly higher than strengths for unprimed steel substrates. Subsequent finite element studies showed a correlation with the experimental results in that peak stress values at the midplane of single-lap-shear (SLS) joints were reduced for primed surfaces. The present study provides a qualitative examination of debond behavior at primed and unprimed bonded surfaces by applying finite element analyses to compute opening (Mode I) and shear (Mode II) components of the strain energy release rate for small debond lengths at selected locations through the bondline thickness of the SLS joint. The bondline-thickness locations where the total strain energy release rate was a minimum correlate well with experimentally observed failure surfaces. In addition, a significant reduction in Mode I was computed for the primed compared to the unprimed joint. This reduction in peel response is consistent with the enhanced strength of the primed joints.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStrain Energy Release Rate Characterization of Structural Adhesive Bonds to Primer Electrodeposited on Steel
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903331
dc.journal.fristpage321
dc.journal.lastpage329
dc.identifier.eissn1528-8889
dc.keywordsSteel
dc.keywordsAdhesives
dc.keywordsBonding
dc.keywordsShear (Mechanics)
dc.keywordsSurface energy
dc.keywordsFinite element analysis
dc.keywordsThickness
dc.keywordsFailure
dc.keywordsAdhesive joints
dc.keywordsBond strength
dc.keywordsStress AND Computer simulation
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record