Show simple item record

dc.contributor.authorS. Mall
dc.contributor.authorE. A. Staubs
dc.contributor.authorT. Nicholas
dc.date.accessioned2017-05-08T23:32:41Z
dc.date.available2017-05-08T23:32:41Z
dc.date.copyrightOctober, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26938#435_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106971
dc.description.abstractCrack growth under sustained load and sustained load with superimposed fatigue cycles at elevated temperatures in a titanium-aluminide alloy (Ti3 Al) was investigated. The objectives were to determine the creep crack growth characteristics and to evaluate the applicability of linear cumulative damage modeling to the Ti3 Al alloy. The linear elastic stress intensity factor, K, was used as a correlating parameter for all the tests. Sustained load tests were used to characterize the time-dependent crack growth behavior at elevated temperatures. The test results showed that sustained load crack growth rate and fracture toughness were relatively insensitive to temperature between 700 and 800°C. Crack growth rates were only a factor of five apart between the slowest and fastest growth rates over this range of temperatures. Several sustained load tests with periodic fatigue cycles (hold-time tests) were used to test the applicability of linear cumulative damage modeling. The model was developed using data from the sustained load and a baseline fatigue test at 750°C. Crack growth rates calculated using the model were accurate for a fatigue cycle with a ten minute hold time, but were up to 2 times less than the growth rates for shorter hold-time tests based on summation of the sustained load and fatigue crack growth rates only. A mixed-mode correction factor added to the model produced more accurate results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleInvestigation of Creep/Fatigue Interaction on Crack Growth in a Titanium Aluminide Alloy
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903354
dc.journal.fristpage435
dc.journal.lastpage441
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsFatigue
dc.keywordsAlloys
dc.keywordsFracture (Materials)
dc.keywordsTitanium aluminide
dc.keywordsStress
dc.keywordsTemperature
dc.keywordsCycles
dc.keywordsModeling
dc.keywordsFatigue cracks
dc.keywordsFatigue testing
dc.keywordsFracture toughness AND Aluminum alloys
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record