Show simple item record

dc.contributor.authorG. Hamatani
dc.contributor.authorM. Ramulu
dc.date.accessioned2017-05-08T23:32:40Z
dc.date.available2017-05-08T23:32:40Z
dc.date.copyrightOctober, 1990
dc.date.issued1990
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26938#381_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106962
dc.description.abstractAn experimental investigation was conducted on the machinability of particulate reinforced ceramic TiB2 /SiC and metal SiC/Al matrix composites by an abrasive water jet. Both piercing and slot cutting experiments were conducted to determine the influence abrasive waterjet machining has on the material. Machining performance was reported by both cut quality as measured by taper and machined surface characteristics. Based on these preliminary experiments, abrasive waterjet machining seems to be a satisfactory machining method for both metal and ceramic matrix composites.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMachinability of High Temperature Composites by Abrasive Waterjet
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2903346
dc.journal.fristpage381
dc.journal.lastpage386
dc.identifier.eissn1528-8889
dc.keywordsComposite materials
dc.keywordsMachinability
dc.keywordsHigh temperature
dc.keywordsMachining
dc.keywordsMetals
dc.keywordsWater
dc.keywordsCeramics
dc.keywordsParticulate matter
dc.keywordsCeramic matrix composites AND Cutting
dc.treeJournal of Engineering Materials and Technology:;1990:;volume( 112 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record