Show simple item record

dc.contributor.authorC. V. Madhusudana
dc.contributor.authorG. P. Peterson
dc.contributor.authorL. S. Fletcher
dc.date.accessioned2017-05-08T23:32:29Z
dc.date.available2017-05-08T23:32:29Z
dc.date.copyrightSeptember, 1990
dc.date.issued1990
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26433#174_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106825
dc.description.abstractIn bolted or riveted joints where the interfacial pressure is not uniform, the total resistance to heat flow in a vacuum is the result of two separate components: the microscopic resistance, which arises due to the constraint of the heat flow through the actual microscopic contact spots, and the macroscopic resistance, which exists because the contact zone, over which these microscopic contact spots are located, is only a fraction of the total interfacial area. Presented here is a review of the recent literature addressing the interfacial pressure distribution and the size of the contact zone, in so far as they affect the heat transfer at these interfaces. A survey of the experimental work on contact pressure and the associated heat transfer in bolted joints is presented, along with the size of the actual contact zone which was identified as an important parameter affecting both the microscopic and the macroscopic resistances. An analysis is performed in which it is formally shown that the exact form of the stress distribution within the contact zone is immaterial for the computation of the total microscopic conductance if the available theoretical results for local solid spot conductance are used. If experimental correlations for local solid spot conductance are used, however, the computed total microscopic conductances may differ about 5 to 10 percent, depending on the type of stress distribution chosen. It is also shown that, for a given load, the total microscopic conductance may be increased by increasing the loading radius and/or the plate thickness.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Effect of Nonuniform Interfacial Pressures on the Heat Transfer in Bolted and Riveted Joints
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905755
dc.journal.fristpage174
dc.journal.lastpage182
dc.identifier.eissn1528-8994
dc.keywordsHeat transfer
dc.keywordsElectrical conductance
dc.keywordsElectrical resistance
dc.keywordsPressure
dc.keywordsFlow (Dynamics)
dc.keywordsHeat
dc.keywordsStress concentration
dc.keywordsVacuum
dc.keywordsStress
dc.keywordsBolted joints
dc.keywordsComputation AND Thickness
dc.treeJournal of Energy Resources Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record