Show simple item record

dc.contributor.authorM. Haciislamoglu
dc.contributor.authorJ. Langlinais
dc.date.accessioned2017-05-08T23:32:29Z
dc.date.available2017-05-08T23:32:29Z
dc.date.copyrightSeptember, 1990
dc.date.issued1990
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26433#163_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/106823
dc.description.abstractA common assumption for annular flow used in the petroleum industry is that the inner pipe is concentrically located inside the flow geometry; however, this is rarely the case, even in slightly deviated wells. Considering the increasing number of directional and horizontal wells, the flow behavior of drilling fluids and cement slurries in eccentric annuli is becoming particularly important. In this paper, the governing equation of laminar flow is numerically solved using a finite differences technique to obtain velocity and viscosity profiles of yield-power law fluids (including Bingham plastic and power law fluids). Later, the velocity profile is integrated to obtain flow rate. Results show that the velocity profile is substantially altered in the annulus when the inner pipe is no longer concentric. Stagnant regions of flow were calculated in the low side of the hole. Viscosity profiles predicted for an eccentric annulus show how misleading the widely used single-value apparent viscosity term can be for non-Newtonian fluids. Profiles of velocity and viscosity in concentric and varying eccentric annuli are presented in 3-D and 2-D contour plots for a better visualization of annular flow. Frictional pressure loss gradient versus flow rate relationship data for power law fluids is generated using the computer program. Later, this data is fitted to obtain a simple equation utilizing regressional analysis, allowing for a quick calculation of friction pressure losses in eccentric annuli. For a given flow rate, frictional pressure loss is reduced as the inner pipe becomes eccentric. In most cases, about a 50-percent reduction in frictional pressure loss is predicted when the inner pipe lies on the low side.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNon-Newtonian Flow in Eccentric Annuli
dc.typeJournal Paper
dc.journal.volume112
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2905753
dc.journal.fristpage163
dc.journal.lastpage169
dc.identifier.eissn1528-8994
dc.keywordsAnnulus
dc.keywordsNon-Newtonian flow
dc.keywordsFlow (Dynamics)
dc.keywordsFluids
dc.keywordsViscosity
dc.keywordsPressure
dc.keywordsPipes
dc.keywordsEquations
dc.keywordsWells
dc.keywordsFriction
dc.keywordsLaminar flow
dc.keywordsDrilling
dc.keywordsCements (Adhesives)
dc.keywordsNon-Newtonian fluids
dc.keywordsPetroleum industry
dc.keywordsGeometry
dc.keywordsGradients
dc.keywordsSlurries
dc.keywordsVisualization AND Computer software
dc.treeJournal of Energy Resources Technology:;1990:;volume( 112 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record