Show simple item record

dc.contributor.authorJ. R. Shadley
dc.contributor.authorJ. R. Sorem
dc.contributor.authorE. F. Rybicki
dc.date.accessioned2017-05-08T23:30:49Z
dc.date.available2017-05-08T23:30:49Z
dc.date.copyrightAugust, 1989
dc.date.issued1989
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28311#225_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105864
dc.description.abstractThe first step in a widely used destructive procedure for measuring through-thickness residual stresses in pipes is a parting-out step in which a coupon is cut from the wall of the pipe. Strain gages provide information on the stress changes that take place at the two surfaces of the coupon when the coupon is removed. Back-computation methods are applied to the laboratory data to provide estimates of the residual stresses that were in the pipe before the coupon was parted-out. The laboratory data needed for the back-computation method are the residual stress distribution in the parted-out coupon, and the stress changes that occured at the surfaces of the coupon when it was parted-out. A simple back-computation method for the parting-out step assumes that the changes that occur in the through-thickness stress distribution of the coupon when it is parted out can be described by a straight line, the end points of the line being determined by the stress changes at the surfaces of the coupon. However, if the width of the coupon in the circumferential direction is small (which is often the case for coupons cut from pipes), this straight line back-computation method can lead to errors in the circumferential residual stress distribution estimate it provides. This paper presents an alternative back-computation procedure based on the Fourier series. Example problems presented in the paper show the Fourier series back-computation method to be accurate, even for narrow coupons, and to be quick and easy to apply.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Fourier Series Back-Computation Method for the Parting-Out Step in Residual Stress Measurements in Pipes
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3265668
dc.journal.fristpage225
dc.journal.lastpage233
dc.identifier.eissn1528-8978
dc.keywordsMeasurement
dc.keywordsStress
dc.keywordsPipes
dc.keywordsComputation
dc.keywordsFourier series
dc.keywordsStress concentration
dc.keywordsResidual stresses
dc.keywordsThickness
dc.keywordsStrain gages AND Errors
dc.treeJournal of Pressure Vessel Technology:;1989:;volume( 111 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record