Show simple item record

dc.contributor.authorJ. E. Jackson
dc.contributor.authorT. Gangjee
dc.contributor.authorI. Haque
dc.date.accessioned2017-05-08T23:30:12Z
dc.date.available2017-05-08T23:30:12Z
dc.date.copyrightJanuary, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26927#74_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105524
dc.description.abstractSolid cylinder upsetting is analyzed using three different approaches for frictional boundary condition modeling. These are (1) constant shear friction factor, (2) experimentally measured frictional stresses, and (3) analytical models accounting for lubricant entrapment and redistribution. All three approaches are implemented in the CFORM finite element code. The error between the three approaches and actual experimental measurements of the material deformation and interfacial pressures is investigated. It is shown that the constant shear friction factor is more accurate for solid film lubricants than for liquid lubricants. However, the calculations indicate that if accurate prediction of near net shape forming processes is to become a reality, improvements need to be made in the characterization of frictional boundary conditions. New theoretical developments applicable to arbitrary shapes and more accurate than the constant shear friction factor approach are needed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLubricant Modeling and Its Effect on Simulation of Material Forming
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226436
dc.journal.fristpage74
dc.journal.lastpage80
dc.identifier.eissn1528-8889
dc.keywordsLubricants
dc.keywordsSimulation
dc.keywordsModeling
dc.keywordsShear (Mechanics)
dc.keywordsFriction
dc.keywordsBoundary-value problems
dc.keywordsShapes
dc.keywordsCylinders
dc.keywordsErrors
dc.keywordsMeasurement
dc.keywordsThin films
dc.keywordsDeformation
dc.keywordsFinite element analysis AND Stress
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record