Show simple item record

dc.contributor.authorS. Murakami
dc.contributor.authorM. Kawai
dc.contributor.authorK. Aoki
dc.contributor.authorY. Ohmi
dc.date.accessioned2017-05-08T23:30:12Z
dc.date.available2017-05-08T23:30:12Z
dc.date.copyrightJanuary, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26927#32_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105517
dc.description.abstractTemperature dependence of multiaxial cyclic behavior of type 316 stainless steel was elucidated experimentally. Cyclic tests under constant total-strain amplitudes were performed for uniaxial tension-compression and circular (non-proportional) strain paths at several temperatures; room temperature, 200°C, 400°C, 500°C, 600°C, and 700°C. The strain amplitudes of the cycles were specified to be 0.2, 0.3, and 0.4 percent under constant strain rate of 0.2 percent per min. A quantitative discussion was made with special emphasis on the difference between material behavior under uniaxial tension-compression strain cycles and multiaxial non-proportional circular ones at these temperatures. The most significant cyclic hardening was observed in the temperature range between 400°C and 600°C for both the proportional and the non-proportional strain cycles. At these particular temperatures, much larger inelastic strain was accumulated until a cyclic stabilization was obtained. Though the effect of non-proportionality in the cyclic strain paths on the cyclic hardening was significant particularly at the temperature below 450°C, it rapdily decreased at higher temperatures.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleTemperature-Dependence of Multiaxial Non-Proportional Cyclic Behavior of Type 316 Stainless Steel
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226430
dc.journal.fristpage32
dc.journal.lastpage39
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsStainless steel
dc.keywordsCycles
dc.keywordsTension
dc.keywordsHardening AND Compression
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record