Show simple item record

dc.contributor.authorYukio Ueda
dc.contributor.authorKeiji Fukuda
dc.date.accessioned2017-05-08T23:30:11Z
dc.date.available2017-05-08T23:30:11Z
dc.date.copyrightJanuary, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26927#1_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105511
dc.description.abstractIn this paper, a new measuring method of three-dimensional residual stresses induced in a butt welded joint is presented. The proposed method is based on a general approach developed by the authors, in which inherent strains (the source of residual stresses) are dealt with as parameters. In the present report, three-dimensional residual stresses in a long body, in which the residual stress distribution is uniform in longitudinal direction, is considered as a special case. It is shown that the measurement of the three-dimensional residual stress, in this case, can be reduced to a combination of two sets of measurements of two-dimensional residual stresses. This method is applied to determine the residual stresses in an actual welded joint and its reliability and practicability are also demonstrated.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleNew Measuring Method of Three-Dimensional Residual Stresses in Long Welded Joints Using Inherent Strains as Parameters—Lz Method
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226427
dc.journal.fristpage1
dc.journal.lastpage8
dc.identifier.eissn1528-8889
dc.keywordsResidual stresses
dc.keywordsWelded joints
dc.keywordsStress
dc.keywordsStress concentration
dc.keywordsMeasurement AND Reliability
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record