Show simple item record

dc.contributor.authorA. Zahoor
dc.date.accessioned2017-05-08T23:30:10Z
dc.date.available2017-05-08T23:30:10Z
dc.date.copyrightApril, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26928#132_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105496
dc.description.abstractA J-integral solution is derived for the three-point bend [SE(B)] specimen. The solution allows analysis for a/W greater than 0.2. The solution is based on an approach that does not require an assumption of net-section yielding in the remaining uncracked ligament. Solutions are presented for both the deformation theory J and modified J. These solutions are suitable for J-resistance curve analysis and require data from only one specimen. Solution for a special case of power law hardening material is presented. Consequences of the separability assumption between load-point displacement and crack length on the resulting J solution are discussed. This work indicates that the plastic η factor from previous solutions is significantly underestimated for a/W less than 0.6. Numerical results show that Jd and JM resistance curves are closer than those obtained from previous solutions. A solution for normalizing the load-displacement curve is also presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleJ-Integral Analysis of Three-Point Bend Specimen
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226444
dc.journal.fristpage132
dc.journal.lastpage137
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsElectrical resistance
dc.keywordsStress
dc.keywordsHardening
dc.keywordsFracture (Materials) AND Displacement
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record