Show simple item record

dc.contributor.authorS. -J. Na
dc.contributor.authorH. -M. Koo
dc.contributor.authorT. -K. Kim
dc.contributor.authorY. -S. Yang
dc.date.accessioned2017-05-08T23:30:09Z
dc.date.available2017-05-08T23:30:09Z
dc.date.copyrightJuly, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26929#314_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105488
dc.description.abstractTo investigate the influence of the shielding gas pressure on the laser cut quality, a series of experiments was conducted for various cutting conditions. The cutting pressure distribution was measured on the workpiece, and also beneath the workpiece with a prepared kerf for various nozzle pressures and nozzle-to-workpiece distances. The cut specimens were inspected by various manners such as dross observation, surface roughness test, and kerf width measurement. Based on the data of pressure measurements and the results of the cut surface inspection, the influence of the considered cutting conditions on the cut quality could be evaluated. The cutting pressure beneath the bottom surface was slightly different from that on the top surface and the pressures on two surfaces had a substantial influence on the dross state. But they possessed only a negligible effect on the surface roughness and kerf width, except the extreme case, where the cut kerf could not be obtained. It could be also revealed that the cutting pressure, which has a close relationship with the nozzle-to-workpiece distance under a given nozzle pressure, affects the range of the available cutting speed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Shielding Gas Pressure in Laser Cutting of Sheet Metals
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226472
dc.journal.fristpage314
dc.journal.lastpage318
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsSheet metal
dc.keywordsLaser cutting
dc.keywordsCutting
dc.keywordsNozzles
dc.keywordsSurface roughness
dc.keywordsLasers
dc.keywordsPressure measurement AND Inspection
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record