Show simple item record

dc.contributor.authorS. Murakami
dc.contributor.authorM. Kawai
dc.contributor.authorY. Ohmi
dc.date.accessioned2017-05-08T23:30:09Z
dc.date.available2017-05-08T23:30:09Z
dc.date.copyrightJuly, 1989
dc.date.issued1989
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26929#278_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/105483
dc.description.abstractThe effects of the history in strain-amplitude and temperature variation on the multiaxial cyclic behavior of type 316 stainless steel were discussed by performing a series of total-strain controlled cyclic tests under uniaxial tension-compression and circular strain paths. Constant strain rate of 0.2 percent/min was specified throughout the tests. The effects of strain amplitude history were examined by changing the strain amplitude between 0.2 percent and 0.4 percent (step-up and step-down tests) at room temperature, 400°C and 600°C. For temperature history dependence tests, the temperature was changed between 200°C and 600°C, 400°C and 600°C, 500°C and 600°C, by specifying a constant strain amplitude of 0.3 percent. It was observed that for the step-up change in strain amplitude the prior cycle showed apparently no influence on the subsequent cyclic accommodation for the uniaxial and the multiaxial cycles at room temperature, 400°C and 600°C. For the decrease in strain amplitude, however, the definite effect of the prior cycle was observed at 400°C, while at higher temperature it disappeared. The effect of the temperature history, on the other hand, appeared only in the case of the temperature-decrease during the uniaxial cycle.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Amplitude-History and Temperature-History on Multiaxial Cyclic Behavior of Type 316 Stainless Steel
dc.typeJournal Paper
dc.journal.volume111
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226467
dc.journal.fristpage278
dc.journal.lastpage285
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsStainless steel
dc.keywordsCycles
dc.keywordsTension AND Compression
dc.treeJournal of Engineering Materials and Technology:;1989:;volume( 111 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record