Show simple item record

dc.contributor.authorZ. F. Sang
dc.contributor.authorG. E. O. Widera
dc.date.accessioned2017-05-08T23:28:01Z
dc.date.available2017-05-08T23:28:01Z
dc.date.copyrightMay, 1988
dc.date.issued1988
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28301#217_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/104379
dc.description.abstractThis paper presents a new kind of piping component—a concentric reducer consisting of plates. Authors performed experimental and elastic, elastic-plastic analyses on five test models having different structural parameters. The elastic stress distribution under hydraulic test pressure, the extension of the plastic region under higher than operating loads and the results of bursting tests are also reported on. Results indicate that under test pressure the maximum stress occurs at the inside of the junction area between the small end of the reducer and the small end tube. Yield and final burst also occurs at this area under higher than operating pressure. Based on the results of the analysis, it can be concluded that the reducer is safe and reliable.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStress and Strength Analysis of Concentric Reducers Consisting of Plates
dc.typeJournal Paper
dc.journal.volume110
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3265592
dc.journal.fristpage217
dc.journal.lastpage224
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsPlates (structures)
dc.keywordsPressure
dc.keywordsJunctions
dc.keywordsStress concentration AND Pipes
dc.treeJournal of Pressure Vessel Technology:;1988:;volume( 110 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record