Show simple item record

dc.contributor.authorP. B. Aswath
dc.contributor.authorD. K. Holm
dc.contributor.authorA. F. Blom
dc.contributor.authorS. Suresh
dc.date.accessioned2017-05-08T23:27:18Z
dc.date.available2017-05-08T23:27:18Z
dc.date.copyrightJuly, 1988
dc.date.issued1988
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26922#278_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/103970
dc.description.abstractThe influence of the very first compression cycle on subsequent Mode I crack growth in notched plates of ductile solids subject to fully compressive cyclic loads has been examined in this work. Whereas stable crack growth occurs from the root of the notch over hundreds of thousands of compression cycles, the amplitude of the very first compression cycle is found to have a decisive effect on the total distance of crack advance. Specifically, a three-fold increase in the stress amplitude during the first compression cycle alone leads to more than a ten-fold increase in the total distance of crack growth during subsequent cycles. Finite element calculations of the crack closure stress levels during cyclic compression are in concurrence with the experimental results of closure stresses (measured from changes in compliance) for a lower strength steel. A brief discussion is also presented of the effects of periodic compressive overloads on crack growth behavior under far-field cyclic compression.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLoad Interaction Effects on Compression Fatigue Crack Growth in Ductile Solids
dc.typeJournal Paper
dc.journal.volume110
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226049
dc.journal.fristpage278
dc.journal.lastpage285
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsSolids
dc.keywordsCompression
dc.keywordsFatigue cracks
dc.keywordsFracture (Materials)
dc.keywordsCycles
dc.keywordsSteel
dc.keywordsFinite element analysis AND Plates (structures)
dc.treeJournal of Engineering Materials and Technology:;1988:;volume( 110 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record