| dc.contributor.author | Akira Kato | |
| dc.date.accessioned | 2017-05-08T23:27:13Z | |
| dc.date.available | 2017-05-08T23:27:13Z | |
| dc.date.copyright | October, 1988 | |
| dc.date.issued | 1988 | |
| dc.identifier.issn | 0094-4289 | |
| dc.identifier.other | JEMTA8-26923#319_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/103939 | |
| dc.description.abstract | The effect of laser welding on prevention of the fracture of cracked shafts of a high carbon steel are presented. Static tensile strength and rotary bending fatigue strength were obtained using shaft specimens of AISI W1 which were welded by a CO2 laser around a precrack. Since the welded region became extremely hard and brittle, both the strengths of laser-welded specimens were lower than those of non-welded specimens. However, the strengths were increased higher than those of non-welded specimens after tempering the specimens. It was found that when tempered at 600°C after laser welding, the rotary bending fatigue strength of specimens with a crack smaller than 12 mm rose similar to that of the base metal, and when tempered at 700° C, the static tensile strength of specimens with a crack smaller than 12mm rose similar to that of the base metal. Therefore, it was shown that the laser welding is very effective to prevent fracture of high carbon steels. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Prevention of Fracture of Cracked Steel Bars Using Laser: Part III—Case of High Carbon Steel | |
| dc.type | Journal Paper | |
| dc.journal.volume | 110 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Engineering Materials and Technology | |
| dc.identifier.doi | 10.1115/1.3226056 | |
| dc.journal.fristpage | 319 | |
| dc.journal.lastpage | 324 | |
| dc.identifier.eissn | 1528-8889 | |
| dc.keywords | Lasers | |
| dc.keywords | Steel | |
| dc.keywords | Carbon steel | |
| dc.keywords | Fracture (Process) | |
| dc.keywords | Laser welding | |
| dc.keywords | Fatigue strength | |
| dc.keywords | Tensile strength | |
| dc.keywords | Base metals | |
| dc.keywords | Brittleness AND Carbon | |
| dc.tree | Journal of Engineering Materials and Technology:;1988:;volume( 110 ):;issue: 004 | |
| dc.contenttype | Fulltext | |