Show simple item record

dc.contributor.authorE. F. Rybicki
dc.contributor.authorA. S. Sandhu
dc.contributor.authorR. B. Stonesifer
dc.contributor.authorJ. R. Shadley
dc.date.accessioned2017-05-08T23:27:13Z
dc.date.available2017-05-08T23:27:13Z
dc.date.copyrightOctober, 1988
dc.date.issued1988
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26923#297_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/103936
dc.description.abstractResidual stresses in a heat treated weld clad plate and test specimens obtained from the plate are determined using a combination of experimental residual stress analysis and a finite element computational model. The plate is 102 mm thick and made of A 533-B Class 2 steel with 308 stainless steel cladding. The plate is heated to 538 C and allowed to cool uniformly. Upon cooling, residual stresses are set up in the clad plate because of the difference between the coefficients of thermal expansion of the plate and the cladding. Residual stress in the clad plate is determined using both a previously verified experimental residual stress analysis technique and a computational model. Removing test specimens from the clad plate can relax the stresses in the cladding. Thus, residual stress distributions were also determined for two types of clad test specimens that were removed from the plate. These test specimens were designed to examine the effect of cladding thickness on residual stresses. Good agreement was found between the experimentally obtained residual stress values and the residual stresses calculated from the computational model. Because of the interest in tests conducted at elevated temperatures and the inherent difficulty in doing experimental residual stress analysis at elevated temperatures, the computational model was applied to examine the effect of elevated temperature on the residual stresses in the test specimens. Peak stresses in the heat treated clad plate were found to approach the yield stress of the cladding material. It was also found that removing a 32 mm clad specimen with cladding on one side reduced the residual stresses in the cladding. However, the residual stresses in the cladding were found to increase when one-half of the cladding thickness was machined away to form the second test specimen geometry. Residual stresses parallel and perpendicular to the weld direction were very similar in magnitude for all cases considered. The effect that heating the test specimens to 204 C has on residual stress distributions was to reduce the residual stress in the cladding and the plate.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental and Computational Residual Stress Evaluation of a Weld Clad Plate and Machined Test Specimens
dc.typeJournal Paper
dc.journal.volume110
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3226053
dc.journal.fristpage297
dc.journal.lastpage304
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsCladding systems (Building)
dc.keywordsResidual stresses
dc.keywordsStress analysis (Engineering)
dc.keywordsTemperature
dc.keywordsHeat
dc.keywordsThickness
dc.keywordsYield stress
dc.keywordsHeating
dc.keywordsThermal expansion
dc.keywordsCooling
dc.keywordsSteel
dc.keywordsFinite element analysis
dc.keywordsGeometry AND Stainless steel
dc.treeJournal of Engineering Materials and Technology:;1988:;volume( 110 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record