Show simple item record

dc.contributor.authorW. Szyszkowski
dc.contributor.authorP. G. Glockner
dc.date.accessioned2017-05-08T23:25:29Z
dc.date.available2017-05-08T23:25:29Z
dc.date.copyrightNovember, 1987
dc.date.issued1987
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28294#368_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102872
dc.description.abstractOptimal contours for heads of cylindrical pressure vessels are discussed. As opposed to the common method of preventing buckling in pressure vessel ends by means of increased wall thickness or local reinforcements, this paper proposes a design for “buckle-free” shapes in which the contour is established/adjusted so as to ensure stable behavior. A previous analysis by the authors, in which compressive stresses were eliminated, is extended so as to take into account the actual flexural rigidity of the wall. The shapes obtained from such buckle-free designs appear to be similar to standard ellipsoidal and torispherical ends and should be acceptable from various design and aesthetic viewpoints.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Rational Design of Thin-Walled Pressure Vessel Ends
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264918
dc.journal.fristpage368
dc.journal.lastpage373
dc.identifier.eissn1528-8978
dc.keywordsPressure vessels
dc.keywordsDesign
dc.keywordsShapes
dc.keywordsStiffness
dc.keywordsWall thickness
dc.keywordsBuckling AND Compressive stress
dc.treeJournal of Pressure Vessel Technology:;1987:;volume( 109 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record