Show simple item record

dc.contributor.authorW. Yu
dc.contributor.authorR. O. Ritchie
dc.date.accessioned2017-05-08T23:24:56Z
dc.date.available2017-05-08T23:24:56Z
dc.date.copyrightJanuary, 1987
dc.date.issued1987
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26913#81_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102553
dc.description.abstractFatigue crack propagation behavior has been examined in a commercial 12.7 mm thick plate of Al-Cu-Li-Zr alloy, 2090, with specific emphasis on the effect of single compression overload cycles. Based on low load ratio experiments on cracks arrested at the fatigue threshold (ΔKTH ), it is found that crack growth at ΔKTH can be promoted through the application of periodic compression cycles, of magnitude two times the peak tensile load. Similar to 2124 and 7150 aluminum alloys, such compression-induced crack growth at the threshold decelerates progressively until the crack re-arrests, consistent with the reduction and subsequent re-generation of crack closure. The compressive loads required to cause such behavior, however, are far smaller in the 2090 alloy. Such diminished resistance of aluminum-lithium alloys to compression cycles is discussed in terms their enhanced “extrinsic” crack growth resistance from crack path deflection and resultant crack closure, and the reduction in the closure from the compaction of fracture surface asperities by moderate compressive stresses.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFatigue Crack Propagation in 2090 Aluminum-Lithium Alloy: Effect of Compression Overload Cycles
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225939
dc.journal.fristpage81
dc.journal.lastpage85
dc.identifier.eissn1528-8889
dc.keywordsAluminum
dc.keywordsAlloys
dc.keywordsCompression
dc.keywordsCycles
dc.keywordsFatigue cracks
dc.keywordsLithium
dc.keywordsStress
dc.keywordsElectrical resistance
dc.keywordsFatigue
dc.keywordsAluminum alloys
dc.keywordsCompacting
dc.keywordsFracture (Process)
dc.keywordsCompressive stress
dc.keywordsZirconium AND Deflection
dc.treeJournal of Engineering Materials and Technology:;1987:;volume( 109 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record