Show simple item record

dc.contributor.authorC. A. Bigelow
dc.date.accessioned2017-05-08T23:24:54Z
dc.date.available2017-05-08T23:24:54Z
dc.date.copyrightJanuary, 1987
dc.date.issued1987
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26913#36_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102543
dc.description.abstractStress-intensity factors are determined for an infinite cracked orthotropic sheet adhesively bonded to an orthotropic stringer. Since the stringer is modeled as a semi-infinite sheet, the solution is most appropriate for a crack tip located near a stringer edge. Both adherends are treated as homogeneous, orthotropic media which are representative of many fiber-reinforced composite materials. The complex variable theory of elasticity was used to obtain a set of integral equations describing the problem. The integral equations are replaced by an equivalent set of algebraic equations, which are solved to obtain the shear stress distribution in the adhesive layer. From these adhesive stresses, the stress-intensity factors are found. A parametric study is conducted to determine the sensitivity of the system to material properties and specimen configuration. Unless the crack tip is very close to or under the stringer, the stress-intensity factor is approximately that of the unstiffened sheet. However, as the crack propagates beneath the stringer, the stress-intensity factor decreases significantly. Increasing the stringer stiffness or the adhesive stiffness also decreases the stress-intensity factor.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleParametric Study of Stress-Intensity Factors in Bonded Composite Stringer Panels
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225929
dc.journal.fristpage36
dc.journal.lastpage39
dc.identifier.eissn1528-8889
dc.keywordsComposite materials
dc.keywordsStress
dc.keywordsAdhesives
dc.keywordsFracture (Materials)
dc.keywordsIntegral equations
dc.keywordsStiffness
dc.keywordsMaterials properties
dc.keywordsEquations
dc.keywordsFiber reinforced composites
dc.keywordsShear (Mechanics)
dc.keywordsStress concentration AND Elasticity
dc.treeJournal of Engineering Materials and Technology:;1987:;volume( 109 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record