Show simple item record

dc.contributor.authorB. Maker
dc.contributor.authorS. K. Samanta
dc.contributor.authorG. Grab
dc.contributor.authorN. Triantafyllidis
dc.date.accessioned2017-05-08T23:24:53Z
dc.date.available2017-05-08T23:24:53Z
dc.date.copyrightApril, 1987
dc.date.issued1987
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26916#164_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102530
dc.description.abstractThis paper presents experimental results obtained for a variety of drawbeads typical of automotive applications, and compares the results with those obtained from the numerical model presented in the first part of this work (Triantafyllidis et al., 1986). The deformation process is divided into two phases: the “locking/clamping” phase as the binder closes to form the sheet around the drawbead, and the “pulling” phase as the panel is formed, causing the material to be drawn through the bead. Metals considered are SKDQ steel, aluminum, and brass. Dry and lubricated conditions are investigated. Good correlations between model and experiment are obtained for strain distributions over the sheet and excellent agreement is observed in the binder clamping forces. Using a Coulomb friction law in the model, horizontal restraining forces are compared to experimental results. The model is shown to accurately predict the influence of variations in material, geometry, and friction conditions. However, the correlation between the model and experiment is not as good in two cases: as the punch (male bead) reaches the “locked” condition, and in the initial stages of “pulling” deformation. Reasons for the discrepancies are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAn Analysis of Drawbeads in Sheet Metal Forming: Part II—Experimental Verification
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225957
dc.journal.fristpage164
dc.journal.lastpage170
dc.identifier.eissn1528-8889
dc.keywordsForce
dc.keywordsDeformation
dc.keywordsFriction
dc.keywordsMetals
dc.keywordsAluminum
dc.keywordsBrass (Metal)
dc.keywordsSteel
dc.keywordsBinders (Materials)
dc.keywordsComputer simulation
dc.keywordsCoulombs
dc.keywordsSheet metal work
dc.keywordsAutomotive industry AND Geometry
dc.treeJournal of Engineering Materials and Technology:;1987:;volume( 109 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record