Show simple item record

dc.contributor.authorS. Y. Zamrik
dc.contributor.authorF. Zahiri
dc.date.accessioned2017-05-08T23:24:50Z
dc.date.available2017-05-08T23:24:50Z
dc.date.copyrightJuly, 1987
dc.date.issued1987
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26917#203_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102507
dc.description.abstractThis paper describes the failure mode observed in two types of FCC structural materials: waspaloy and type 316 stainless steel as a result of biaxial low cycle fatigue at elevated temperatures. Torsional cycling was applied at high as well as low strain ranges. Creep effect was assessed by introducing hold periods of 90 seconds in the waspaloy tests and 30 minutes in the stainless steel tests. Data obtained from fatigue and creep-fatigue tests have shown that the failure process in the two materials was controlled by two failure mechanisms which depended, to different degrees, on the state of stress, dwell time, and temperature. The failure mechanisms were assessed by observing crack growth in each material under strain level and temperature. In the waspaloy, the mode of crack growth was more temperature than stress dependent, while in the stainless steel, it was stress dependent. The microstructure analysis showed that each type of crack growth was caused by variations in slip band formation, stages of crack initiation and propagation, secondary cracking and cracking of grain boundaries. Creep showed more interaction with fatigue in the stainless steel material than in the waspaloy.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleBiaxial Creep-Fatigue Failure Characteristics in Two FCC Materials
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225964
dc.journal.fristpage203
dc.journal.lastpage208
dc.identifier.eissn1528-8889
dc.keywordsCreep
dc.keywordsFatigue
dc.keywordsFailure
dc.keywordsFracture (Materials)
dc.keywordsTemperature
dc.keywordsStainless steel
dc.keywordsStress
dc.keywordsFailure mechanisms
dc.keywordsFracture (Process)
dc.keywordsLow cycle fatigue AND Grain boundaries
dc.treeJournal of Engineering Materials and Technology:;1987:;volume( 109 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record