Show simple item record

dc.contributor.authorP. R. Cetlin
dc.contributor.authorJ. L. N. Marcos
dc.date.accessioned2017-05-08T23:24:48Z
dc.date.available2017-05-08T23:24:48Z
dc.date.copyrightOctober, 1987
dc.date.issued1987
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26918#276_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/102487
dc.description.abstractBased on a previous literature analysis of the stress-strain curves superposition method for the evaluation of the redundant deformation factor φ, an experimental program is proposed and carried out for SAE 1018 steel. The method is applied for tensile and compressive testing, and for multiple and single passes up to 30 percent logarithmic strains. For single passes, results for tensile testing were reasonably in accordance with those in the literature. For multiple passes, work hardening was higher for 2 or 3 passes than for 1 pass, contrarily to results for Copper in the literature. Compression testing should not be used for φ evaluation if one wants to obtain φ values similar to those in the literature.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRedundant Deformation Factor Evaluation Through the Stress-Strain Curves Superposition Method in Round Section Bar Drawing—Experimental Results
dc.typeJournal Paper
dc.journal.volume109
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225977
dc.journal.fristpage276
dc.journal.lastpage281
dc.identifier.eissn1528-8889
dc.keywordsStress-strain curves
dc.keywordsDeformation
dc.keywordsTesting
dc.keywordsCompression
dc.keywordsTensile testing
dc.keywordsWork hardening
dc.keywordsCopper AND Steel
dc.treeJournal of Engineering Materials and Technology:;1987:;volume( 109 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record