Show simple item record

dc.contributor.authorM. Hishida
dc.contributor.authorM. Saito
dc.contributor.authorK. Hasegawa
dc.contributor.authorY. Matsuo
dc.contributor.authorK. Enomoto
dc.date.accessioned2017-05-08T23:23:14Z
dc.date.available2017-05-08T23:23:14Z
dc.date.copyrightMay, 1986
dc.date.issued1986
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28269#226_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101587
dc.description.abstractCrack growth behavior of Type 304 stainless steel in a simulated BWR water environment was investigated for the quantitative characterization of subcritical flaw growth in BWR piping systems. Crack propagation rates under corrosion fatigue and stress corrosion cracking were generated using compact specimens. The effects of several parameters on the rates were discussed. Furthermore, surface crack growth behavior was examined under different modes of cyclic loading, and results were discussed in comparison with compact specimen data. The corrosion fatigue crack propagation rates strongly depended on the frequency and the stress ratio. The rates became higher as the frequency lowered and the stress ratio increased. No effect from dissolved oxygen concentration and heat treatment of the steel was observed in tests, where transgranular cracking mainly took place. Stress corrosion cracking rate data indicated K ISCC was above 15 MPa•m1/2 . On the other hand, surface crack growth behavior included scattered crack propagation rates. However, the relationship between da /dN and ΔK was basically similar to that obtained in the compact specimens, except under given test conditions, where the acceleration for the crack growth rate at a crack tip on the panel surface was different from that at the deepest point.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Study on Crack Growth Behavior for Austenitic Stainless Steel in High Temperature Pure Water
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264773
dc.journal.fristpage226
dc.journal.lastpage233
dc.identifier.eissn1528-8978
dc.keywordsFracture (Materials)
dc.keywordsStainless steel
dc.keywordsWater
dc.keywordsHigh temperature
dc.keywordsSurface cracks
dc.keywordsCorrosion
dc.keywordsStress corrosion cracking
dc.keywordsStress
dc.keywordsBoiling water reactors
dc.keywordsCrack propagation
dc.keywordsFatigue cracks
dc.keywordsOxygen
dc.keywordsPiping systems
dc.keywordsHeat treating (Metalworking)
dc.keywordsFatigue
dc.keywordsSteel AND Fracture (Process)
dc.treeJournal of Pressure Vessel Technology:;1986:;volume( 108 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record