Show simple item record

dc.contributor.authorK. Tokimasa
dc.contributor.authorK. Tanaka
dc.date.accessioned2017-05-08T23:23:13Z
dc.date.available2017-05-08T23:23:13Z
dc.date.copyrightMay, 1986
dc.date.issued1986
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28269#158_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101577
dc.description.abstractUsing the FEM program, the effects of geometry, residual stress and the elasticplastic behavior of material on the collapse strength of a tube is analyzed and the following results are obtained. The plastic collapse pressure is maximum when the circumferential residual stress on the inner surface is tensile and is equal to 0.7σy . The plastic collapse pressure of a perfectly round tube can be approximately estimated by the following equation independent of the plastic-hardening behavior of the material: P = 2σ0.04 (D /t − 1)/(D /t )2 . Based on these FEM results, a new formula is presented to evaluate the collapse strength of a tube.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFEM Analysis of the Collapse Strength of a Tube
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264764
dc.journal.fristpage158
dc.journal.lastpage164
dc.identifier.eissn1528-8978
dc.keywordsFinite element methods
dc.keywordsCollapse
dc.keywordsFinite element model
dc.keywordsPressure
dc.keywordsStress
dc.keywordsHardening
dc.keywordsEquations
dc.keywordsFormulas AND Geometry
dc.treeJournal of Pressure Vessel Technology:;1986:;volume( 108 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record