Show simple item record

dc.contributor.authorSection XI Task Group for Piping Flaw Evaluation
dc.contributor.authorASME Code
dc.date.accessioned2017-05-08T23:23:10Z
dc.date.available2017-05-08T23:23:10Z
dc.date.copyrightAugust, 1986
dc.date.issued1986
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28273#352_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101545
dc.description.abstractThis report summarizes the methods and bases used by the Task Group for Piping Flaw Evaluation to develop allowable flaw sizes for the American Society of Mechanical Engineers (ASME) Boiler and Pressure Vessel Code, Section XI, IWB-3640, “Evaluation Procedures and Acceptance Criteria for Austenitic Piping.” Because the Task Group identified two flaw-related failure mechanisms for light water reactor (LWR) austenitic steel piping, two sets of allowable flaw size tables were developed. One set is presented for base metal and nonflux welds, which have high flaw tolerance; a second set is provided for flux welds that can have lower relative toughness and flaw tolerance. Application of the flaw evaluation procedures for cast austenitic piping requires material classification on a case by case basis. Allowable flaw sizes are presented in tabular form, with the allowable part-through flaw depth defined as a function of load and flaw length. Tables are presented for both longitudinal and circumferential flaws, and normal/upset and emergency/faulted conditions. This report also recommends crack growth rate and weld residual stress data needed to perform subcritical crack growth analyses in accordance with Section XI, Appendix C, “Evaluation of Flaws in Austenitic Piping.” These data and the allowable flaw size tables provide the means to determine the acceptabiality for continued service of austenitic piping containing flaws whose sizes exceed the standards specified in Section XI, IWB-3514.3, “Allowable Indication Standards for Austenitic Piping.”
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEvaluation of Flaws in Austenitic Steel Piping
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264797
dc.journal.fristpage352
dc.journal.lastpage366
dc.identifier.eissn1528-8978
dc.keywordsPipes
dc.keywordsSteel
dc.keywordsStress
dc.keywordsLight water reactors
dc.keywordsWelded joints
dc.keywordsFracture (Materials)
dc.keywordsASME
dc.keywordsFailure mechanisms
dc.keywordsAcceptance criteria
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsToughness AND Base metals
dc.treeJournal of Pressure Vessel Technology:;1986:;volume( 108 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record