Show simple item record

dc.contributor.authorG. D. Galletly
dc.date.accessioned2017-05-08T23:23:09Z
dc.date.available2017-05-08T23:23:09Z
dc.date.copyrightNovember, 1986
dc.date.issued1986
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28277#521_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101536
dc.description.abstractA simple equation is proposed which will enable a designer to estimate the onset of buckling in internally pressurized steel torispherical end closures. The equation applies to both crown and segment ends and spun ones. Apart from a factor which accounts for strain hardening, the same equation applies to both carbon steel and austenitic stainless steel torispheres. The proposed equation for the allowable internal pressure was checked against all known experimental buckling results and a minimum factor of safety of 1.5 was found. The equation was also checked against a number of full-scale vessels, some of which had failed in service. Once again, the equation was found to be satisfactory.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Simple Design Equation for Preventing Buckling in Fabricated Torispherical Shells Under Internal Pressure
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264824
dc.journal.fristpage521
dc.journal.lastpage526
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsDesign
dc.keywordsBuckling
dc.keywordsEquations
dc.keywordsShells
dc.keywordsStainless steel
dc.keywordsVessels
dc.keywordsWork hardening
dc.keywordsSteel
dc.keywordsCarbon steel AND Safety engineering
dc.treeJournal of Pressure Vessel Technology:;1986:;volume( 108 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record