Show simple item record

dc.contributor.authorA. Selz
dc.date.accessioned2017-05-08T23:23:09Z
dc.date.available2017-05-08T23:23:09Z
dc.date.copyrightNovember, 1986
dc.date.issued1986
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28277#518_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101534
dc.description.abstractThere has been a need for some time to provide rules for allowable stresses for short-time and infrequent loading such as earthquake and wind loads in Section VIII, Division 1 of the Boiler and Pressure Vessel Code. Such rules exist in Section VIII, Division 2, in Section III, and in many other Codes. Division 1 has been silent on the subject. This has caused some manufacturers to make their own rules, and some to overdesign their hardware. Neither situation is without problems. Therefore, in 1979 the Boiler and Pressure Vessel Committee undertook to develop rules for Section VIII, Division 1. This work resulted in the addition of paragraph UG-23(d) to the Code, in the Summer, 1983 Addenda. The paragraph permits an increase in general primary membrane stress of 20 percent for earthquake and wind loads for temperatures below the creep regime.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleIncreased Allowable Stresses for Earthquake and Wind Loads in Section VIII, Division 1
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue4
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.3264823
dc.journal.fristpage518
dc.journal.lastpage520
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsEarthquakes
dc.keywordsWind
dc.keywordsMembranes
dc.keywordsBoilers
dc.keywordsASME Boiler and Pressure Vessel Code
dc.keywordsCreep
dc.keywordsTemperature
dc.keywordsPressure vessels AND Hardware
dc.treeJournal of Pressure Vessel Technology:;1986:;volume( 108 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record