Show simple item record

dc.contributor.authorE. F. Rybicki
dc.contributor.authorJ. R. Shadley
dc.date.accessioned2017-05-08T23:22:38Z
dc.date.available2017-05-08T23:22:38Z
dc.date.copyrightApril, 1986
dc.date.issued1986
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26909#99_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101235
dc.description.abstractThe accuracy of a destructive, experimental method for the evaluation of through-thickness residual stress distributions is investigated. The application of the method is to a welded pipe that has been subjected to a residual stress improvement process. The residual stress improvement process introduces gradients in the stress distribution. The question of interest is how well the back-computation method used to interpret the experimental data represents the residual stress distribution for this type of stress profile. To address this question, a finite element model was used to provide a reference stress solution for comparison with the back-computation results of the experimental method. Three-dimensional finite element stress analyses were also conducted to simulate the cutting steps of the destructive laboratory procedure. The residual stress distributions obtained by the back-computation procedure were then compared with the reference stress solutions provided by the finite element model. The comparisons show agreement and indicate that good results can be expected from the experimental method when it is applied to a pipe that has been subjected to a residual stress improvement process, provided that the axial gradient of stress is not too large.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Three-Dimensional Finite Element Evaluation of a Destructive Experimental Method for Determining Through-Thickness Residual Stresses in Girth Welded Pipes
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225866
dc.journal.fristpage99
dc.journal.lastpage106
dc.identifier.eissn1528-8889
dc.keywordsFinite element analysis
dc.keywordsPipes
dc.keywordsResidual stresses
dc.keywordsThickness
dc.keywordsStress
dc.keywordsComputation
dc.keywordsFinite element model
dc.keywordsGradients
dc.keywordsStress concentration
dc.keywordsStress analysis (Engineering) AND Cutting
dc.treeJournal of Engineering Materials and Technology:;1986:;volume( 108 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record