Show simple item record

dc.contributor.authorA. R. Ragab
dc.contributor.authorA. T. Abbas
dc.date.accessioned2017-05-08T23:22:37Z
dc.date.available2017-05-08T23:22:37Z
dc.date.copyrightJuly, 1986
dc.date.issued1986
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26911#250_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101224
dc.description.abstractIn this work, commercially pure aluminum sheets in both the as-received and annealed conditions are tested in uniaxial and biaxial tension. Biaxial stretching is performed in dies giving different degrees of stress biaxiality. Resulting effective stresses and plastic strains are estimated according to the original Hill’s theory in the two situations where planar anisotropy is either neglected or taken into consideration. In both situations discrepancies between biaxial and uniaxial flow curves are observed. By analyzing the above uniaxial and biaxial test results according to the flow rule associated with a yield function recently proposed by Hill, a new material index describing the anisotropic behavior has been evaluated. This new material behavior description realized a satisfactory agreement between work-hardening characteristics of the tested aluminum sheets under various biaxial stress systems. The same tested aluminum sheet materials have been then tested in order to determine their forming limit curves. Correlation between these curves and the theoretical predictions of limit strains according to various instability analyses, is sought through the use of the above description of material work-hardening.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAssessment of Work-Hardening Characteristics and Limit Strains of Anisotropic Aluminum Sheets in Biaxial Stretching
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225877
dc.journal.fristpage250
dc.journal.lastpage257
dc.identifier.eissn1528-8889
dc.keywordsAluminum
dc.keywordsWork hardening
dc.keywordsStress
dc.keywordsFlow (Dynamics)
dc.keywordsAnisotropy
dc.keywordsSheet materials AND Tension
dc.treeJournal of Engineering Materials and Technology:;1986:;volume( 108 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record