Show simple item record

dc.contributor.authorE. G. Thomsen
dc.contributor.authorF. D. Negroni
dc.date.accessioned2017-05-08T23:22:36Z
dc.date.available2017-05-08T23:22:36Z
dc.date.copyrightJuly, 1986
dc.date.issued1986
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26911#218_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101217
dc.description.abstractIt is shown that it is possible to use a three-point method for the evaluation of tensile data for some ductile metals. The experimental data show also that average tensile stresses and axial tensile stresses along the axis of the specimens during the necking portion of a test remain linear functions of the effective strain. Prediction made by the use of an electronic calculation sheet and the use of a computer program yield results which are in substantial agreement with the experimental results. The three-point method would seem to reduce the experimental work necessary to obtain σ versus ε curves and apparently would permit higher testing speeds than those of ε ≈ 0.03 used in this investigation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDetermination of Tensile Properties by a Three-Point Method
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225871
dc.journal.fristpage218
dc.journal.lastpage221
dc.identifier.eissn1528-8889
dc.keywordsMetals
dc.keywordsTesting
dc.keywordsComputer software
dc.keywordsFunctions
dc.keywordsNecking AND Tension
dc.treeJournal of Engineering Materials and Technology:;1986:;volume( 108 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record