Show simple item record

dc.contributor.authorR. H. Warnes
dc.contributor.authorR. R. Karpp
dc.contributor.authorP. S. Follansbee
dc.date.accessioned2017-05-08T23:22:35Z
dc.date.available2017-05-08T23:22:35Z
dc.date.copyrightOctober, 1986
dc.date.issued1986
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-26912#335_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101203
dc.description.abstractThe freely expanding ring test (ERT) is a conceptually simple test for determining the stress-strain behavior of materials at large strains and at high strain rates. This test is conducted by placing a thin ring of test material in a state of uniform radial expansion and then measuring its subsequent velocity-time history. The ring is usually propelled by a high explosive driving system. The test has not become popular in the materials property community, however, because there has been some concern about how the launching of the ring sample with an explosively generated shock wave might affect the properties to be measured. To determine the suitability of the ERT for these fundamental investigations, a series of experiments was performed on a carefully controlled material—oxygen-free electronic fully annealed copper. Recovered ring samples were analyzed and the change in hardness determined. Comparisons of the ERT data with that from Hopkinson bar tests at strain rates of about 5 × 103 s−1 indicate that the shock-induced hardness is approximately equivalent to a strain hardening of 5 percent. ERT data on this material at strain rates up to 2.3 × 104 s−1 are presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Freely Expanding Ring Test—A Test to Determine Material Strength at High Strain Rates
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.3225891
dc.journal.fristpage335
dc.journal.lastpage339
dc.identifier.eissn1528-8889
dc.keywordsCopper
dc.keywordsShock waves
dc.keywordsTesting equipment
dc.keywordsStrength (Materials)
dc.keywordsStress
dc.keywordsShock (Mechanics)
dc.keywordsOxygen
dc.keywordsWork hardening AND Explosives
dc.treeJournal of Engineering Materials and Technology:;1986:;volume( 108 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record