Show simple item record

dc.contributor.authorD. L. Turner
dc.date.accessioned2017-05-08T23:22:15Z
dc.date.available2017-05-08T23:22:15Z
dc.date.copyrightDecember, 1986
dc.date.issued1986
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26414#347_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/101020
dc.description.abstractInterest in developing a high-production automatic joining method for quality offshore pipelines led to full-scale evaluation of the flash-butt welding process. During the past five years, two separate flash-butt welding machines have been used to provide over 1100 welds in 914-mm (36-in.) o.d. pipe for test and evaluation. Increased speed and the quality inherent in a fully automatic welding process were the two major incentives for the development project. It is estimated that flash-butt welding can produce up to 377 joints per day in 914-mm (36-in.) o.d. × 25-mm wall thickness pipe—twice what can be produced by conventional manual (shielded metal arc) welding techniques. This paper describes the flash-butt welding process and plans to install production equipment aboard a semi-submersible laybarge in the near future.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFlash-Butt Welding of Large-Diameter Oil and Gas Pipelines
dc.typeJournal Paper
dc.journal.volume108
dc.journal.issue4
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.3231288
dc.journal.fristpage347
dc.journal.lastpage351
dc.identifier.eissn1528-8994
dc.keywordsWelding
dc.keywordsPipelines
dc.keywordsPipes
dc.keywordsProduction equipment
dc.keywordsWall thickness
dc.keywordsUnderwater pipelines
dc.keywordsSemi-submersible offshore structures
dc.keywordsWelded joints
dc.keywordsMetals
dc.keywordsMachinery AND Joining
dc.treeJournal of Energy Resources Technology:;1986:;volume( 108 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record